Skutt EnviroVent 2: Kiln Vent

Product details

Technical Overview

SKUTT KILNS EnviroVent 2 Ventilation System Downdraft Ventilation System See PRODUCT VIDEOS tab for installation instruction video The Skutt EnviroVent 2 requires a 120 Volt outlet. The fan motor moves 140 cfm of air out of the room. Make sure you you consult with an HVAC professional to be sure the room is provided with adequate make-up air. The EnviroVent® 2 comes with 8 ft. of 3 in. diameter, heavy duty, flexible aluminum ducting to go from the plenum cup to the vent motor. If more is needed to vent to the outside, you may order additional ducting from Skutt. Do not use thin walled dryer ducting. The fan motor comes equipped with a 3 in. exhaust tube designed to pass through most walls and roofs. The maximum exiting temperature when installed correctly is 160 ºF. If a vent is ordered with a kiln, the holes in the lid and slab are often drilled in the factory. If there are no holes drilled, consult the EnviroVent® 2 manual and drill the holes according to the recommendations for your model. If you are venting a kiln between 12 cu/ft and 24 cu/ft you will need to use a Dual Intake Kit to draw air from 2 areas of the kiln. This kit may also be used to vent 2 kilns under 12 cu/ft. VENT 2 KILNS With 1 MOTOR Now you can vent 2 kilns with a single vent with the Skutt EnviroVent 2. The new 140 CFM Motor allows you to vent 2 kilns up to 12 Cubic Feet each, or one kiln between 12 and 24 Cubic Feet, with one Envirovent 2 Motor . WALL MOUNTED MEANS NO HEAT AND NO VIBRATION The new design of the kiln ventilation system is wall mounted. This moves the vent motor away from under the kiln so the motor is no longer exposed to the heat and can no longer transfer any vibration into the kiln. SPRING LOADED PLENUM CUP RETAINS SEAL THROUGHOUT FIRING As your kiln heats up the brick